Rotherham Corporation
1964
AEC Renown 3B3RA
Roe H39/31F

There has also been a 1961 Rotherham Corporation Bridgemaster on site (link here) and the easy way to tell them apart was the front off side mudguard. It is easier to show than describe so the close up on the left is the Renown and the one on the right is the Bridgemaster.

          
As you can see the Renown’s mudguard follows through the body where as the Bridgemaster’s body goes over the mudguard and this was always the case with these two buses.
This Renown has the AEC code of 3B3RA which meant it had an AEC 9.6 litre six cylinder engine with a 4 speed synchromesh gearbox and air brakes. There was only one alternative the 3B2RA and the only difference was it had the Monocontrol direct selection gearbox. One thing I have noticed which I find strange is that this Renown’s drivers cab door slides backwards on the outside of the body to open it normally the door slid forwards inside the cab.

A full list of Renown codes can be seen here.

———

If you look at the position of the cab door opening in relation to the front wheel it is obvious why the sliding door is external. If it was internal the wheel arch leaves nowhere for it to go, unless the door were made unreasonably shallow to pass over the top of the mudguard. For the same reason Lodekkas and other low-height buses always had hinged cab doors. The only exception seems to be the Albion Lowlander, as bodied by NCME and Alexander, where the coachbuilders raised the cab ceiling above the level of the main upper saloon floor (and raised the foremost seats to perch on top of the cab). That gave sufficient headroom to allow an internally-sliding cab door of conventional style.

David Jones

———

I’m not absolutely certain but weren’t these the only Renowns bodied by Roe? (although obviously to a Park Royal design)

Ian Wild

———

Yes, Ian. As was common in the sixties and seventies, whenever Park Royal was hard pressed, they subcontracted to their (smaller) Yorkshire partner. Geoff Lumb’s excellent book on C H Roe records in words and pictures that the Rotherham Renowns were built at Crossgates.

David Oldfield

———

11/09/12 – 06:43

I think I have a photo somewhere in my possession that show an EYMS Renown at Roes too, or am I dreaming there?

Graham